40MM grenade rubber slug types.
 

So I'm interested in buying like one or two of those rubber slug type 40MM grenades and it seems the main brand that is available for them is King Arms but on 7 or 8 sites i found that list that particular cartridge all are out of stock. Anyone know why this is or where I could get them?

Not sure if these are compatible with your shell (because you didn't mention what brand it was)

http://www.airsoftparts.ca/store2/in...roducts_id=973

Edit: If you are looking for the shell itself, they have it on the same site

http://www.airsoftparts.ca/store2/in...roducts_id=972

Get them from a Canadian retailer. Madbulls are great.

http://www.airsoftparts.ca/store2/in...roducts_id=972

http://www.airsoftparts.ca/store2/in...roducts_id=973

Edit: Green beat me to it.....

Wow. The one site I did not look at and the place I got my launcher from. I feel dumb now....

Re: 40MM grenade rubber slug types.
 

So what exactly are your plans for these slugs? Some games won't allow them. Some games they are not effective. Double check that your local games permit them or you just might be shooting them at your basement wall.

Also, searching a field for these things after launching them could be a PITA.

Mad Bull is making the rubber heads with a softer material now, much safer for gaming now.

Sorry to hi-jack but op got his answere.

What about these two?
http://www.airsoftparts.ca/store2/in...roducts_id=908
http://www.airsoftparts.ca/store2/in...roducts_id=808
Any advice as to if these are just different bb quantity or is one of better build?

the M922A1 is okay for CQB only on propane. pointless in outdoor environment as you cannot run it on CO2 at a PSI that is worth fielding.

the XM108HP, XM204HP and XMPB4 are the ones a few of us will only use. CO2 works great but you will need to watch your MED with PSI at or above 600PSI. have to be even more careful when it's hot out!

Thanks guys, just ordered the xm204hp today and know exactly what I'll be doing with the next pay cheque! Also, what psi are they ment to run at and what am I going to run em at?

for the kings, I'd start off with 400-450 psi until you know it's range.

if playing and targeting your friends do it at 300psi if you want to reach out 700psi

i hope you got a longer launcher cus the kings will stick out the end of pretty much anything short.

btw, kings don't fit in the xm203 short.

Any of you guys have King Arms M433s? I have not tested mine out yet and I am new to 40MMs so I hardly know what to do.

reset valve, if required
gas nade first!
load bb's
load nade into launcher
take off safety
fire

repeat