3X Eotech Magnifier
 

I recently bought the 3X eotech magnifier at airsoftpark.com to use with my eotech 552 and i can't seem to get the reticle in the middle of the magnifier. I got it centred but the reticle is showing at the bottom of the magnifier. I cant seem to lower the tilt of the magnifier so the reticle of the eotech is dead on centred. i turned on every screw there is and nothing seems to adjust the tilt of the magnifier.

So my question, is there a way to adjust the tilt of the magnifier? i need it to point a little lower.

The magnifier came with the qd flip mount.
http://www.airsoftpark.com/product_i...oducts_id=8896

Thanks.

Had the same problem, I bought a rail spacer to elevate my eotech

Like this : http://www.airsoftparts.ca/store2/in...roducts_id=205

Pick up this. There was a few used ones that were for sale in the parts thread. I think groombug was selling a couple. http://www.ebairsoft.com/tactical-eo...10-p-1635.html

And for the price of the EB one I'd find a RS one on the classifieds lol.

Just for reference, the 553 is the one that usually doesn't need a riser right? Or is it all the "taller" models?

i bought both from them aswell and i got them lined up now what i did was i took the scope off the mount and turned it all around and it lines up. but if you flip.it off you have to go and press it back in place but it will stay


hope it works !

I had similar problem. Turned out the Aimpoint was not properly placed on the rail and missaligned, even if the dot co-witnessed the sights.

I aligned everything separatly and the magnifier and Aimpoint where dead on.

My mistake i didnt buy from them i bought from www.airsoftpartshop.com

Still the same product

I bought the L3 from DX before they got banned, but now DX has some Eotechs again, and the L3 would fit perfectly as it sights higher than 552, and it's shorter so you can place the magnifier behind easily :)