APS2 SV bolt wont budge
 

No matter how hard i pull back the bolt wont budge. What should i do? Is my gun broken?

Really having fun with that gun, aren't you? Take the two stock screws out, behind the trigger guard and the one farther forward of it, and separate the stock from the reciever. Then take off the trigger assembly and pull the cylinder out from the receiver. Look around for anything that might be causing the fuck up.

Ya, I got it yesterday I'm probably just gonna replace it with a Vsr-10 :(. I don't have the guts to do that internal stuff on the aps2. It has happened before but all i had to do was loosen the screw connecting the receiver to the stock. Aww what to do what to do.

I removed the trigger assembly and the bolt still won't budge, i'm really worried!

I need help

Where are you located bro...I might be able to help you out.

SHA DO

The USA I just go on here because i find you guys and girls to be the most helpful and responsive posters. Since you can't physically help, a few online tips would be great!

Pictures?

No problems my friend, we'll try.
In removing the trigger assembly, did you notice that the set pin was still intact?? Sometimes the broken pieces from with in the trigger assembly will find their way into the small space between the cylinder and the receiver and cause binding issues. However this is very rare.

Is the box slot in the bottom of the upper receiver clear of any debris??
As well, are there any problems with the bolt handle cycling up and down??

If all intact and clear of obstructions, check to see if the rear screw for your scope rail may be too long (or over tightened) and be binding down onto the cylinder/bolt pull assembly.

It could also be that (if the cylinder is upgraded) any of the three set screws or pins that reinforce the cylinder could be sticking out too far and when the bolt was reinstalled, it would have been forced into the receiver, making it a real pain to get back out.

Seeing as we cannot physically help you with this issue, any pictures would be helpful.

SHA DO

Well guys i'm am still going to keep the maruzen but instead of buying replacements i'm going with a bar-10 to replace it in my sniper collection. I might have a video up on youtube of my problem under maruzenman which is my account name for now though i'm just gonna get a bar-10. Thanks to all that help for now i'm just gonna leave my gun alone.

(remember to keep updated with maruzenman on youtube)

And to respond to Sha Do

Cylinder is not upgraded
I'm pretty sure the scope rail isn't the problem.
Airsoft extreme said i might have messed something up when screwing the screws in causing my bolt to not move.

They can only be refering to the two screws that hold the stock to the main, and if they were to long in the first place and you (or anyone elso) over tightened either of them, it could result in the cylinder being bent causing the problem (especially if the cylinder is stock). If this is what has indeed happened, all you can do is forceably remove the cylinder. But I would recommend you remove the pull handle and strip everything off of the receiver (including the barrel and also the cylinder head) first, then use a hammer to push the cylinder out of the receiver. Use a vice padded with an old towel and be careful not to over tighten the vice.

Best of luck bro;
SHA DO

can you life the bolt handle up?

Yes i can lift the bolt up, and i might have bent the bolt. I don't trust myself enough to take it apart, is there a way i could use to forse it out without taking the internals out.