Airsoft Canada - View Single Post - WETTI/AWSS - M4/SCAR/HK416

W0lf · May 12th, 2011, 19:10

hey guys, im experiencing a small problem with my wetti m4, it happened before i switched to a dytac MUR1 upper, and aswell after.

the piston and rod seem to get stuck about halfway through a cycle, causing the bolt to not return forward, and sometimes just continuously spraying all the propane out.
also, since getting the MUR1, because of this problem, the brass tube and barrel retract about an inch, causing misfeeds, and the next mag loaded to not seat at all.

the person i bought the MUR 1 told me the problem of the brass tube moving around could be fixed by putting a nice thick layer of electrical tape around the ring that seats the brass tube into the receiver, but it doesnt seem to be doing the trick for me.

any suggestions before i miss half a season because i had to order whole new internals for a gun i havent even gamed yet?

May 12th, 2011, 19:10	#797
W0lf Trader rating Join Date: Oct 2007 Location: Niagara Falls, ON	hey guys, im experiencing a small problem with my wetti m4, it happened before i switched to a dytac MUR1 upper, and aswell after. the piston and rod seem to get stuck about halfway through a cycle, causing the bolt to not return forward, and sometimes just continuously spraying all the propane out. also, since getting the MUR1, because of this problem, the brass tube and barrel retract about an inch, causing misfeeds, and the next mag loaded to not seat at all. the person i bought the MUR 1 told me the problem of the brass tube moving around could be fixed by putting a nice thick layer of electrical tape around the ring that seats the brass tube into the receiver, but it doesnt seem to be doing the trick for me. any suggestions before i miss half a season because i had to order whole new internals for a gun i havent even gamed yet? __________________ "If I don't know it, Google does."