Mmmm.. I can't tell it went fine for the Metal body...
got to do some mod about the fitting for the body pins... there was a misalignement... Got to drill the holes... were too tiny...
also, Stripped the screw for Mag release button... found another screw... that fits the hole perfectly...
To end all this... I have to dismantle all this ... 2 times... because the hop up was not setup correctly...
But now !!! It's all fine !!! Fiou... hard work... but worth the shot ! METAL BODY Finally !
Looks better than before... Duct tape is not so sweet on AEG !
