[Whiskey]

Originally Posted by ▼Stripes▲

I recently put an 11.1v lipo battery in my ares G36c. I am using a 408fps spring as well. This combination broke the teeth on my sector gear and I am considering just replacing the entire gearset. Anyone have any recommendations as to what gears I should get? Not asking where to get them just looking for advice. I don't want to buy a new set of gears to have them break on me. Or buy a set that's way more than I need.

First, the only reason the sector gear shed some teeth was improper shimming from the factory., I just sold my ARES G36c (cylinder matched to barrel and shimmed the mechbox) and she loved my 11.1v 2200mah 25C lipo. As for recommendations for a new gear set, I would go with a set of SHS 16:1 gears, best bang for you're buck. You could go Promy, but for the price you could by 4 sets of SHS gears In my experience, the gear failure rate of the promy's is higher. The only SHS gear set failure I have had was in my P90, 13:1 SHS gears an m110 spring on a 14.8v 4000mah 25c Lipo battery, she failed somewhere around 44RPS. It wasn't a train wreck either, just the point on the bevel gear where it is pressed together came loose. The new owner installed a new SHS bevel gear and it is running just fine with that set up. As far as running a Mosfet, if you do, make damn sure it is not active/passive breaking, due to the micro switch installed, they will not work together very nice.
-Ryan.