Airsoft Canada - View Single Post - WE Hi-Capa 5.1 slide release doesn't stay in place.

Splashx · May 16th, 2012, 11:56

mine too, with use, the slide release is making a larger hole in the plastic lower frame.
so this piece is moving too much easily inside out.

The only thing I found out to correct this problem would be making a hole on the right hand of the release, and install a screw so you'll have to unscrew it to put it out....
or just get a metal lower frame. A lock-pin on the release could have helped... but would damage the plastic frame faster

I also tested to put some paint on the round part that goes inside the frame to put some friction. Too much paint would make it unmoveable up and down (what we don't want) but it helped

May 16th, 2012, 11:56	#3
Splashx Trader rating Join Date: May 2007 Location: Near Quebec city	mine too, with use, the slide release is making a larger hole in the plastic lower frame. so this piece is moving too much easily inside out. The only thing I found out to correct this problem would be making a hole on the right hand of the release, and install a screw so you'll have to unscrew it to put it out.... or just get a metal lower frame. A lock-pin on the release could have helped... but would damage the plastic frame faster I also tested to put some paint on the round part that goes inside the frame to put some friction. Too much paint would make it unmoveable up and down (what we don't want) but it helped Last edited by Splashx; May 16th, 2012 at 12:16..