Airsoft Canada - View Single Post - Need new bucking for Tanfoglio Limited Custom

ardo · March 1st, 2013, 08:19

I was wondering if any bucking made for VSR-10 may fit the KWC/Cybergun Tanfoglio, like the Maple Leaf bucking that ehobbyasia sells for TM/KJW/WE guns? Also, if anyone could recommend a local supplier.

I'm also getting confused by the "degree" specification: what does "70/75/80 degree" mean? Is it related to rubber hardness, and should I go for hard as opposed to soft because of higher speeds of a CO2 pistol?

Last night I found wear marks on the inside of the outer barrel, made by the hop-up adjustment bracket. The bracket was completely loose, and bucking was ripped. I'm hoping to just teflon-tape over the new bucking, thus making it non-adjustable but allowing the inner barrel to glide freely.

TIA.

March 1st, 2013, 08:19	#1
ardo Trader rating Join Date: Feb 2011 Location: Toronto	Need new bucking for Tanfoglio Limited Custom I was wondering if any bucking made for VSR-10 may fit the KWC/Cybergun Tanfoglio, like the Maple Leaf bucking that ehobbyasia sells for TM/KJW/WE guns? Also, if anyone could recommend a local supplier. I'm also getting confused by the "degree" specification: what does "70/75/80 degree" mean? Is it related to rubber hardness, and should I go for hard as opposed to soft because of higher speeds of a CO2 pistol? Last night I found wear marks on the inside of the outer barrel, made by the hop-up adjustment bracket. The bracket was completely loose, and bucking was ripped. I'm hoping to just teflon-tape over the new bucking, thus making it non-adjustable but allowing the inner barrel to glide freely. TIA. Last edited by ardo; March 1st, 2013 at 08:24..