Swapped out the hop up and no change...
Quote:
Originally Posted by Deadpool
Have you removed the lower and, putting the upper on it'S back, tried to cycle the bolt back slowly?
Even remove the springs, just to see if anything catches anywhere.
|
I can pull the lower right out and put the pin back through the upper receiver and it will hold the rods in correct alignment. Everything slides nicely with no binding what so ever.
Quote:
Originally Posted by Basic-Wedge
Ultimately, the sear. A less likely possibility would be misalignment of the selector switch's shaft as it passes through the trigger block.
|
I'll tear down the trigger box tomorrow. With everything else checking out it is the only thing left that can go wrong.