Quote:
Originally Posted by jjkfeng
there's no cycling, the trigger feels a tighter but I think it's probably not the problek. i tried with full green gas, and a good mag *tested with my other tm glock* I was only able to fire one shot. I checked the nozzle, the oring looked fine however the spring felt weak..could it be that?
the nozzle felt stiff and would get stuck sometimes.
|
Well, if there is cycling or even spraying of the gas, and if you are unable to pull the trigger, it means that the trigger is not resetting properly or engaging the sear to release the hammer.
Even if you assume that it is the nozzle/nozzle return spring, there still should be some kind of "response" when you pull the trigger on the second shot. My assumption is that the gun (slide, trigger, sear, etc) is not resetting properly after the first shot/cycle which causes no response when you try to pull the trigger the second time.
After the first shot, does your trigger reset forward or still retracted?
Quote:
Originally Posted by Animalmother
Do you guys ever have problem wry BBS rolling out the front firing?
Or is that just a problem when the hopup is off?
|
Probably because the hop up is not adjusted to stabilize the bb before it is shot out. Check your hop up dial, check to make sure your hop up halves are tightly screwed in place.