![]() |
|
|
||||||||
|
Home | Forums | Register | Gallery | FAQ | Calendar |
Retailers | Community | News/Info | International Retailers | IRC | Today's Posts |
![]() |
|
Thread Tools |
![]() |
#1 |
XM108HP doesnt hold gas - Need advice
I have a strange issue now. I reassemble it correctly (as mentioned in the other thread), but it doesn't hold gas. When I fill it, all the gas comes out through the BB holes and when I open it up again, two of the bearings have fallen out of the valve into the lower half where the spring/plunger sit.
Any ideas?
__________________
H&K G36c (KWA) / Glock 18c (TM) / Kimber LAPD SWAT Custom (TM) / Mossberg M500 (ACM) ![]() |
|
![]() |
![]() |
![]() |
#2 |
![]() ![]() ![]() Join Date: Feb 2005
Location: Swimming in a pool of Xpresspost receipts.... Toronto - 400/401
|
It is normal for bearings to fall out during disassembly.
It's probably not primed. After assembly, push the release valve all the way up with a screwdriver.. you should feel the bearings reset Other possibilities are one or more warped bearing holes in the main gas valve, or damaged o-rings. Inspect them all before re-assembly. |
![]() |
![]() |
![]() |
#3 |
I think it is the big o-ring problem.
|
|
![]() |
![]() |
![]() ![]() |
|
Bookmarks |
|
|
![]() |